BlinkenArea ultimate logo board
Stefan Schuermans
change firmware to match new switch in schematic, use mode switch to lock current animation
a40d3a7 @ 2012-06-10 10:55:19
| .. | ||
|---|---|---|
| .gitignore | version 1.0.0 | 2012-06-06 19:34:07 |
| battery_holder.svg | version 1.0.0 | 2012-06-06 19:34:07 |
| bulb_back.svg | version 1.0.0 | 2012-06-06 19:34:07 |
| bulb_front.svg | version 1.0.0 | 2012-06-06 19:34:07 |
| capacitor.svg | version 1.0.0 | 2012-06-06 19:34:07 |
| led.svg | version 1.0.0 | 2012-06-06 19:34:07 |
| microcontroller.svg | version 1.0.0 | 2012-06-06 19:34:07 |
| resistor.svg | version 1.0.0 | 2012-06-06 19:34:07 |
| schematic.svg | version 1.0.0 | 2012-06-06 19:34:07 |
| smd_solder_done.svg | version 1.0.0 | 2012-06-06 19:34:07 |
| smd_solder_pads.svg | version 1.0.0 | 2012-06-06 19:34:07 |
| smd_solder_part.svg | version 1.0.0 | 2012-06-06 19:34:07 |
| smd_solder_start.svg | version 1.0.0 | 2012-06-06 19:34:07 |
| smd_solder_tin.svg | version 1.0.0 | 2012-06-06 19:34:07 |
| switch.svg | version 1.0.0 | 2012-06-06 19:34:07 |
| transistor.svg | version 1.0.0 | 2012-06-06 19:34:07 |
