<html><head><title>Blinker - UDPv4 Sender</title></head><body><h1>Blinker - UDPv4 Sender</h1><p>The UDPv4 sender module sends a stream using UDP version 4 acrossa network.It supports the static and dynamic variants of the BLP, EBLP and MCUFprotocols.</p><h2>Configuration</h2><p>The configuration of the UDPv4 sender module with name <code>NAME</code>is located in the <code>udp4senders/NAME</code> subdirectory.</p><h3>Input Stream</h3><p>The file <code>instream</code> contains the name of the stream toread.The frames received from this stream are sent over the network.</p><h3>Protocol</h3><p>The protocol to use is configured in the file <code>protocol</code>.It can contain the string <code>blp</code>, <code>eblp</code> or<code>mcuf</code> to select the BLP, EBLP or MCUF protocol respectively.</p><h3>Bind Address</h3><p>The file <code>bind</code> contains the local address to bind to.It must contain the IP address and the port, i.e. a string<code><IP>:<port></code> (hostnames are not supported).If the local address should be determined automatically, the filecan contain <code>0.0.0.0:0</code>.</p><h3>Static Destinations</h3><p>Static destinations to supply with a network stream in the configuredprotocol can be configured in the subdirectory <code>destinations</code>.Each static destination is configured in an own subdirectory.E.g. the configuration for a static destination with name<code>local</code> resides in the subdirectory<code>destinations/local</code>.</p><p>The configuration inside a static destination consists of the followingsettings:</p>